нестабильно работает udp для сервера, но клиент уже в порядке, правда тоже через раз, буду решать проблемы с подлючением, все же xod имеет много багов и не может полностью убрать разного рода проблемы
This takes the temp and relative humidity from a dht11 and converts the information to a "feels like temp". the humidity , temp and "feels like temp" are displayed on an lcd (i2c). the "feels like temp" is also mapped to a nrgb led. the led turns blue when cold, green when comfortable and red when hot.
It became necessary to create a filament counter for your 3d printer. During the writing of the program, I created a new multiplication node. I used the hall sensor and the ssd1306 LED display on the i2c bus .
With this library, you can use several nodes at the same time, as well as rotate the servo not only with the help of a condition, but also with the help of a pulse signal!